Port-Channel Load-Balance - Cisco Sx350 Cli Manual

Port Channel Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
When the auto mode is configured and there are not received LACP messages on
all port-candidates then one of candidates is joined. When the first LACP message
is received the port is disjoined and LACP starts to manage port joining.
Example
The following example forces port
operation.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

46.2 port-channel load-balance

To configure the load balancing policy of the port channeling, use the port-channel
load-balance Global Configuration mode command. To reset to default, use the no
form of this command.
Syntax
port-channel load-balance
no port-channel load-balance
Parameters
•
src-dst-mac—Port channel load balancing is based on the source and
destination MAC addresses.
•
src-dst-mac-ip—Port channel load balancing is based on the source and
destination of MAC and IP addresses.
Default Configuration
src-dst-mac is the default option.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
1 to join port-channel 1 without an LACP
gi1
interface gi11
channel-group 1 mode on
{src-dst-mac | src-dst-mac-ip}
port-channel load-balance src-dst-mac
46
914