Connecting A 3-Kw Ac Power Supply To An Ac Power Source; Connecting A 3-Kw Universal Ac/Dc Power Supply To An Ac Power Source; Connecting A 3-Kw Universal Ac/Dc Power Supply To A Dc Power Source - Cisco Nexus 9504 Hardware Installation Manual

Connecting a 3-kW AC Power Supply to an AC Power Source

Warning
Connecting a 3-kW AC Power Supply to an AC Power Source
Step 1 For each 3-kW AC power supply, connect an AC power cable to the AC power source and to the power receptacle on
the power supply.
Step 2
Verify that the Output Power LED turns on and becomes green.
What to do next
When the power supplies are operating and the switch is fully powered, you are ready to connect the switch
to the network.

Connecting a 3-kW Universal AC/DC Power Supply to an AC Power Source

The 3-kW Universal AC/DC power supply can be connected to either a 200-to-277-V AC circuit equipped
with a Saf-D-Grid receptacle. This procedure is for connecting the power supply to an AC power source.
Before you begin
The power switch on the power supply must be turned off (power switch set to 0).
Step 1 Verify that the power switch on the power supply is turned off (0).
Step 2
Connect the Saf-D-Grid connector on the AC power cable to the Saf-D-Grid receptacle for the AC power source.
Step 3 Connect the Saf-D-Grid connector on the other end of the power cable to the Saf-D-Grid receptacle on the power supply.
Step 4
Turn on the power supply by pressing its power switch to on (1).
Step 5 Verify that the Output Power LED turns on and becomes green.
What to do next
After you finish connecting the power supplies to the power source and the power supplies are operating, you
connect the switch to the network.

Connecting a 3-kW Universal AC/DC Power Supply to a DC Power Source

The 3-kW Universal AC/DC power supply can be connected to a 240-to-380-V DC circuit equipped with
positive, negative, and ground terminals. This procedure is for connecting the power supply to a DC power
source.
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
30
Statement 1018 Supply Circuit
To reduce risk of electric shock and fire, take care when connecting units to the supply circuit so that
wiring is not overloaded.
Installing a Chassis