Radius-Server Host Source-Interface-Ipv6 - Cisco 300 Series Cli Manual

40
RADIUS Commands

40.5 radius-server host source-interface-ipv6

Use the radius-server host source-interface-ipv6 Global Configuration mode
command to specify the source interface whose IPv6 address will be used as the
source IPv6 address for communication with IPv6 RADIUS servers. Use the no
form of this command to restore the default configuration.
Syntax
interface-id
radius-server host source-interface-ipv6
no radius-server host source-interface-ipv6
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined on the outgoing interface
and selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the source IPv6 address is an IPv6
address defined on the interfaces and selected in accordance with RFC 6724.
If the source interface is not the outgoing interface, the source IPv6 address is the
minimal IPv6 address defined on the source interface and matched to the scope
of the destination IPv6 address is applied.
If there is no available source IPv6 address, a SYSLOG message is issued when
attempting to communicate with an IPv6 RADIUS server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# radius-server host source-interface-ipv6 vlan 100
793 OL-32830-01 Command Line Interface Reference Guide