Honda 2004 Odyssey Service Manual page 126

Special Tools Required
• Driver 07749-0010000
• Attachment, 42 x 47 mm 07746-0010300
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Test the alternator and regulator before you
remove them (see page 4-22).
2. Remove the alternator (see page 4-27).
3. If the front bearing needs replacing, remove the
pulley locknut with a 10 mm wrench (A) and a
22 mm wrench (B). If necessary, use an impact
wrench.
A
4. Remove the three flange nuts and the insulator
from the alternator.
B
5. Remove the end cover (A) and seal ring (B).
B
6. Remove the brush holder (A) and seal ring (B).
B
A
A
(cont'd)
4-39