Honda 2004 Odyssey Service Manual page 53

Standards and Service Limits
Steering
Item
Steering wheel Rotational play measured at outside
edge
Starting load measured at outside
edge
Gearbox Angle of rack guide screw loosened
from locked position
Pump Output pressure with shut-off valve
closed
Power steering Capacity
fluid Use Honda Power Steering Fluid
Power steering Deflection with 98 N (10 kgf, 22 lbf)
pump belt applied mid-way between pulleys
NOTE: Adjust a Tension (measured with belt tension
new belt to the gauge)
new belt spec,
run the engine
for 5 minutes,
then readjust it
to the used belt
spec.
Suspension
Item
Wheel alignment Camber
Caster
Total Toe
Front wheel turning angle
Aluminum wheel Runout
Steel wheel Runout
Wheel bearing End play
2-20
Measurement
With engine
running
With engine
running
For fluid change
For system
overhaul
Measurement
Front
Rear
Front
Front
Rear
Inside wheel
Outside wheel
Axial
Radial
Axial
Radial
Front
Rear
Qualification Standard or New
0 10 mm (0 0.39 in.)
30 N (3.1 kgf, 6.8 lbf)
20° Max
8,300 8,800 kPa (85 90 kgf/cm , 1,210 1,280 psi)
0.4 (0.42 US qt)
1.1 (1.16 US qt)
Used belt: 13.0 16.5 mm (0.51 0.65 in.)
New belt: 8.5 11.0 mm (0.33 0.43 in.)
Used belt: 390 540 N (40 55 kgf, 88 120 lbf)
New belt: 740 880 N (75 90 kgf, 170 200 lbf)
Qualification Standard or New
0°00' 1°
0°30' 45'
2°07' 1°
0 2 mm (0 1/16 in.)
0 2 mm (0 1/16 in.)
41°46' 2°
33°28' (Reference)
0 0.7 mm (0 0.03 in.)
0 0.7 mm (0 0.03 in.)
0 1.0 mm (0 0.04 in.)
0 1.0 mm (0 0.04 in.)
0 0.05 mm (0 0.002 in.)
0 0.05 mm (0 0.002 in.)
Service Limit
2
Service Limit
2.0 mm (0.08 in.)
1.5 mm (0.06 in.)
2.0 mm (0.08 in.)
1.5 mm (0.06 in.)