Starting System
Starter Overhaul (cont'd)
Starter Brush Inspection
11. Measure the brush length. If it is not within the
service limit, replace the brush holder assembly.
Brush Length
Standard (New): 15.8 16.2 mm (0.62 0.64 in.)
Service Limit:
11.0 mm (0.43 in.)
4-12
Starter Brush Holder Test
12. Check that there is no continuity between the ( )
brush holder (A) and ( ) brush holder (B). If there
is continuity, replace the brush holder assembly.
B
A
13. Insert the brush (A) into the brush holder, and bring
the brush into contact with the commutator, then
attach a spring scale (B) to the spring (C). Measure
the spring tension at the moment the spring lifts off
the brush.
Spring Tension:
15.7 17.7 N (1.6 1.8 kgf, 3.53 3.97 lbf)
A
B
A
B
C