Honda 2004 Odyssey Service Manual page 120

Special Tools Required
• Driver 07749-0010000
• Attachment, 42 x 47 mm 07746-0010300
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Test the alternator and regulator before you
remove them (see step 1 on page 4-22).
2. Remove the alternator (see page 4-27).
3. If the front bearing needs replacing, remove the
pulley locknut with a 10 mm wrench (A) and a
22 mm wrench (B). If necessary, use an impact
wrench.
A
4. Remove the three flange nuts (A) and the screw (B)
from the alternator, then remove the plate terminal
(C).
B
A
B
C
5. Remove the washer nut (A) and insulator (B) from
the ''B'' terminal, then remove the end cover (C)
and dust seal (D).
A
B
6. Remove the brush holder.
C
D
(cont'd)
4-33