Configuring The Snmp Operation; Configuring The Tcp Operation - H3C SR6600-X Configuration Manual

Step
12. (Optional.) Specify the source
IP address for UDP packets.
NOTE:
Use the display nqa result or display nqa statistics command to verify the UDP jitter operation. The
display nqa history command does not display the UDP jitter operation results or statistics.

Configuring the SNMP operation

The SNMP operation measures the time for the NQA client to get a response packet from an SNMP
agent.
To configure the SNMP operation:
Step
1. Enter system view.
Create an NQA operation
2.
and enter NQA operation
view.
3. Specify the SNMP type and
enter its view.
4. Specify the destination
address of SNMP packets.
5. (Optional.) Specify the source
port of SNMP packets.
6. (Optional.) Specify the source
IP address of SNMP packets.

Configuring the TCP operation

The TCP operation measures the time for the NQA client to establish a TCP connection to a port on the
NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see
To configure the TCP operation:
Command
source ip ip-address
Command
system-view
nqa entry admin-name
operation-tag
type snmp
destination ip ip-address
source port port-number
source ip ip-address
"Configuring the NQA
18
Remarks
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface, and
the interface must be up.
Otherwise, no UDP packets can be
sent out.
Remarks
N/A
By default, no NQA operation is
created.
N/A
By default, no destination IP address is
specified.
By default, no source port number is
specified.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
SNMP packets can be sent out.
server."