System Log & Trap Settings; System Severity Settings - D-Link DGS-3000 Series Reference Manual

Log Type
Index
Time
Level
Log Text
Click the Find button to display the log in the display section according to the selection made.
Click the Clear Log button to clear the entries from the log in the display section.
Click the Clear Attack Log button to clear the entries from the attack log in the display section.
The Switch can record event information in its own log. Click Go to go to the next page of the System Log window.
System Log & Trap Settings
The Switch allows users to configure the system log source IP interface addresses here.
To view the following window, click System Configuration > System Log Configuration > System Log & Trap
Settings as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
IPv6 Address
Click the Apply button to accept the changes made for each individual section.
Click the Clear button to clear all the information entered in the fields.

System Severity Settings

The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent. The level at which the
alert triggers either a log entry or a trap message can be set as well. Use the System Severity Settings window to set
the criteria for alerts. The current settings are displayed below the System Severity Table.
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
In the drop-down menu the user can select the log type that will be displayed.
Severity - When selecting Severity from the drop-down menu, a secondary tick must be
made. Secondary ticks are Emergency, Alert, Critical, Error, Warning, Notice,
Informational and Debug. Select the All check box to view all information in the log.
Module List - When selecting Module List, the module name must be manually entered.
Available modules are MSTP, ERROR_LOG and ERPS.
Attack Log - When selecting Attack Log all attacks will be listed.
A counter incremented whenever an entry to the Switch's history log is made. The table
displays the last entry (highest sequence number) first.
Display the time in days, hours, minutes, and seconds.
Display the level of the log entry.
Display text describing the event that triggered the history log entry.
Figure 2-24 System Log & Trap Settings window
Description
Enter the IP interface name used.
Enter the IPv4 address used.
Enter the IPv6 address used.
28