Table of Contents
Advertisement
4 Web-based Switch Configuration
If ForceUnauthorized is selected, the port will remain in the unauthorized state, ignoring all
attempts by the client to authenticate. The Switch cannot provide authentication services to the client
through the interface.
If Auto is selected, it will enable 802.1X and cause the port to begin in the unauthorized state,
allowing only EAPOL frames to be sent and received through the port. The authentication process
begins when the link state of the port transitions from down to up, or when an EAPOL-start frame is
received. The Switch then requests the identity of the client and begins relaying authentication
messages between the client and the authentication server.
The default setting is Auto.
Direction: Sets the administrative-controlled direction on the port. The possible field values are:
Both – Specify the control is exerted over both incoming and outgoing traffic through the controlled
port selected in the first field.
In – Disables the support in the present firmware release.
Click Apply to make the configurations take effect.
Security > 802.1X > 802.1X User
The 802.1X User page allows user to set different local users on the Switch. Enter a 802.1X User name,
Password and Confirm Password. Properly configured local users will be displayed in the table.
Click Add to add a new 802.1X user.
Security > 802.1X > Radius Accounting Settings
The page allows user to turn of accounting state in 802.1x.
Security > 802.1X > 802.1X Authentication RADIUS Server
The 802.1X Authentication RUAIUS of the Switch allows user to facilitate centralized user administration as
well as providing protection against a sniffing, active hacker.
Figure 4.119 - Security > 802.1X > 802.1X User
Figure 4.120 - Security > 802.1X > Radius Accounting Settings
D-Link DGS-2000 Series Ethernet Switch User Manual
8
8
7
7
Advertisement
Table of Contents
