System Services Commands - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Use system services commands to configure and monitor system information for a
DWS-1008 switch. This chapter presents system services commands alphabetically. Use the
following table to located commands in this chapter based on their use.
clear banner motd
Deletes the message-of-the-day (MOTD) banner that is displayed before the login prompt for
each CLI session on the switch.
Syntax: clear banner motd
Defaults: None
Examples: To clear a banner, type the following command:
DWS-1008# clear banner motd
success: change accepted
Note: As an alternative to clearing the banner, you can overwrite the existing banner with an
empty banner by typing the following command: set banner motd ^^
clear history
Deletes the command history buffer for the current CLI session.
Syntax: clear history
Defaults: None
Examples: To clear the history buffer, type the following command:
DWS-1008# clear history
success: command buffer was flushed.
clear prompt
Resets the system prompt to its previously configured value. If the prompt was not configured
previously, this command resets the prompt to its default.
Syntax: clear prompt
Defaults: None
Access: Enabled
D-Link Systems, Inc.

System Services Commands

Access: Enabled
Access: All
System Services Commands
12