Configuring An F_Port Mode Top Talker Monitor - Brocade Communications Systems Brocade 8/12c User Manual

27
SAN Top Talker monitoring
8. Click Destination to launch the Port Properties dialog box for the Destination port.
9. Click Source to to launch the Port Properties dialog box for the Source port.
10. Click the minimize button to hide this dialog box when it is not needed.

Configuring an F_port mode Top Talker monitor

NOTE
An F_port mode Top Talker and an end-to-end monitor cannot be configured on the same F_port.
You must delete the end-to-end monitor before you configure the F_port mode Top Talker.
NOTE
An F_port mode Top Talker and a fabric mode Top Talker cannot be configured on the same fabric.
You must delete the fabric mode Top Talker before you configure the F_port mode Top Talker.
To configure an F_port mode Top Talker monitor, complete the following steps.
1. Select the port on which you want to monitor Top Talker data.
2. Select Monitor > Performance > Top Talkers.
3. Click Select.
4. Select F Port to select the F_port to monitor in the Top Talker Mode list.
5. Click OK on the Top Talker Selector dialog box.
6. Select the number of Top Talkers (1 through 20) to display from the Display list.
7.
8. Select whether you want to monitor the receive (Rx) flow or the transmit (Tx) flow for the port
798
•
Source Switch/Port
•
Destination
•
Destination Switch/Port
The Top Talkers - F Port Mode for F_Port dialog box displays.
The Top talker Selector dialog box displays.
You can only select one F_port on which to enable the Top Talker monitor.
Top Talker is enabled on the selected port.
Select how often you want the Top Talker to refresh (10, 20, 30, 40, or 50 seconds, or 1
minute) from the Refresh Interval list.
from the Flow list.
•
DID
•
Destination Port
Brocade Network Advisor SAN User Manual
53-1002167-01