Turning The Printer On - Xante FilmMaker 4 User Manual

Fig. 1.28 Connect Power Cord to Printer
Never use a damaged power cord. Check the cord and plug monthly and replace
immediately if you find any damage.

Turning the Printer On

Press the | on the power switch to turn on the printer (fig. 1.29).
Fig. 1.29 Turn Printer On
Printer initialization takes approximately 60 seconds. When Ready/Idle displays, the
printer is ready to accept print jobs.
Due to shipping movement, you should calibrate your printer after setup. For
procedures, see the More X-ACT section of "PostScript Features (AccelaFont, DPI,
Linearization, LPI, Margins, More X-ACT, and VM)" in chapter 2 (Macintosh) or 3
(PC).
Following initialization, a start-up page prints if that feature is enabled. This page lists
the selected resolution, installed RAM, hard disk identities, page count, enabled
interfaces, and network information. Review this page to be sure that the printer is
configured properly. See "Printing a Startup Page" later in this chapter and "Start-up
Page" in chapter 4 for details.
1-16 Introduction and Installationbb