Storing The Printer; Moving The Printer - Xante PlateMaker 3 Manual

• Make sure the output tray does not overfill. Overfilling can block
media as it comes out and cause a printer jam.
• Check the power cord and plug monthly and replace
immediately if you find damage.

Storing the Printer

Use the following procedure when storing the printer for an extended
period.
1. Turn off the printer. Unplug the power cord from the power
source.
2. Remove all media from the multipurpose feeder. Close the
multipurpose feeder and, if necessary, the top cover. See
chapter 2 for instructions.
3. Store the printer and media properly.
a. Store the printer and media in an area with a temperature
of 32˚ to 95˚ F (0˚ to 35˚ C) and a relative humidity of
15% to 80% with no condensation.
b. Store the printer and media in the original containers or
cover them to protect from dust.

Moving the Printer

Use the following procedure when moving the printer.
Warning! The printer weighs approximately 58.5 lbs (26.5 kg)
without toner, cassettes, and media installed. Always
have two people lift the printer, using the recessed grip
areas on the right and left sides only.
1. Turn off the printer and unplug the power cord from the power
source.
9-4 Maintenance and Specificationsbb ________________________