Table of Contents
Advertisement
Overview
Name
External fresh-gas outlet
Gas cylinder connectors
Hanger yoke system
Gas cylinder holder
Gas cylinder park holder
Advanced Cylinder Sup-
port
Support of Infinity ID
accessories
Breathing bag arm
Airway pressure gauge
Total flow tube
Holder for hoses and
cables
Cable holder with cable
channels
Side folding table exten-
sion
Pull-out writing tray
Pressure measuring lines
for gas cylinders
Auxiliary power sockets
Workplace light
42
Description
– Allows use with external non-rebreathing systems,
e.g.:
– Mapleson
– Kuhn
– Bain
– Magill
– Waters
Enable the device to be supplied with gases from the
gas cylinders.
Enables the connection of gas cylinders with a pin-
index connector.
Used to fix the gas cylinders.
Can hold an additional gas cylinder.
On devices that are equipped with Advanced Cylinder
Support, the gas cylinder valves can also remain open
during operation with the central supply.
Allows the use of Dräger Infinity ID accessories with
the following functions:
– Generates a message when the maximum period
of use is exceeded for the breathing circuit, the
water trap, the CO
– Generates a message when the breathing circuit is
incorrectly connected
– Generates a message when the CO
not present or is not locked
Used to attach the breathing bag to the breathing sys-
tem.
Mechanically measures the airway pressure and dis-
plays it on an analog indicator.
Indicates the total fresh-gas flow.
Used for storing and winding up central supply hoses
and cables on the rear of the device.
Used for routing hoses and cables on the rear of the
device.
Used to extend the work surface.
Used to extend the work surface.
– Display of gas cylinder pressure
– On correspondingly equipped devices, an alarm is
issued when gas cylinders are empty.
Allow other devices to be connected.
Used for additional illumination of the work surface.
|
Instructions for use
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
absorber, and the flow sensors
2
absorber is
2
Advertisement
Table of Contents
