Table of Contents
Advertisement
Alarm or alarm limit
CBM mode Pause, Mon-
1)
FiO
low
2
1)
Configurable
FiO
high
2
2)
FiO
low
2
2)
inAgent high
2)
Apnea (no CO
)
2
2)
etCO
high
2
2)
etCO
low
2
2)
inCO
high
2
2)
FiO
high
2
Configurable
2)
inAgent low
2)
Not activated
xMAC low
Paw
MV high
Configurable
MV low
Apnea (no flow)
Apnea (no pressure)
1) With inspiratory O
measurement with O
2
2) With integrated patient-gas measurement module
3) The alarm remains suppressed until respiratory activity is detected.
4) This alarm is only activated if the MV low alarm limit is also activated.
10.4.1
Activating the alarms related to volume
The upper alarm limit for MV is deactivated at the start of the ventilation, but can be
set during the ventilation.
The MV low alarm is delayed in certain cases and is issued as follows:
– No sooner than 45 seconds after a case starts
– No sooner than 45 seconds after changing to a mode with greater breathing
support, see page 310
– No sooner than 45 seconds after an Apnea (no flow) alarm or an Apnea (no
pressure) alarm
– No sooner than 45 seconds after one of the following maneuvers: Inspiration
Hold, Expiration Hold, or one-step recruitment
10.4.2
Resetting the Apnea (no CO
Prerequisite: The device is equipped with the "integrated patient-gas measurement
module".
When changing to a ventilation mode with higher breathing support, the Apnea (no
CO
2
specified in table "Alarm delay, alarm escalation, and alarm deescalation".
|
Instructions for use
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
itoring
PSV with ΔPsupp
Is adopted.
Configurable
Is adopted.
3)
Off
Off
Is adopted.
Off
Configu-
4)
rable
Off
sensor
2
) alarm is reset. If the apnea situation persists, an alarm appears after the time
Man / Spon,
Ext. FGO
<5 hPa (cmH
O)
2
Not measured
Is adopted.
Configurable
Configurable
Not measured
Off3)
Off
) alarm
2
Alarms
VC,
VC - AF,
PC,
PSV with ΔPsupp ≥5 hPa
(cmH
O)
2
Is restored or remains active.
On
197
Advertisement
Table of Contents
