Table of Contents
Advertisement
Technical data
Pin 9
Housing
USB port
Type
Supported devices
Network port
Information
Type
Transfer speed
Connector for external workplace light
15.20
Relevant standards
Information
IEC 60601-1
Medical electrical equipment
IEC 60601-1-2
Medical electrical equipment
IEC 60601-1-8
Medical electrical equipment
ISO 80601-2-13
Medical electrical equipment
296
Not used
SHLD-GND
Only connect USB mass storage devices that do not
have their own power supply. Do not connect any
charging cables.
Connector type A; USB 2.0
USB flash drive formatted with FAT16 or FAT32
Only for Dräger Remote Service
Only connect devices or networks that meet the
requirements of IEC 60950-1 / IEC 62368-1 for
ungrounded SELV circuits or the requirements of
IEC 60601-1 (as of the 2nd edition) for touchable sec-
ondary circuits with a maximum nominal voltage of
24 V DC.
RJ45 plug
100Base-TX, IEEE 802.3 Clauses 24 and 25 (requires
at least a CAT5 cable)
10Base-T, IEEE 802.3 Clause 14 (requires at least a
CAT3 cable)
Only for workplace lights approved by Dräger, see list
of accessories.
In addition to the standards listed here, this medical
device also meets various other standards.
Part 1:
General requirements for basic safety and essential
performance
Part 1-2:
General requirements for basic safety and essential
performance - Collateral standard: Electromagnetic
disturbances - Requirements and tests
Part 1-8:
General requirements for basic safety and essential
performance - Collateral standard: Alarm systems -
General requirements, tests and guidance for alarm
systems in medical electrical equipment and medical
electrical systems
Part 2-13:
Particular requirements for basic safety and essential
performance of an anaesthetic workstation
|
Instructions for use
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
Advertisement
Table of Contents
