Table of Contents
Advertisement
Alarms
After the Auto On initialization is complete, the time remaining until the system test
is displayed in Standby mode. While the device is being shut down, the
corresponding symbol is shown in the status display, see page 35.
For a final test of the operational readiness of the device, it is only necessary to
perform some brief manual checks after the automatic system test.
9.2
Storing the device
Proceed as follows when the device is to be disconnected from the mains power
supply for longer than 2 weeks:
1. Set the main switch to the
2. Disconnect the power plug.
This will prevent deep discharge of the battery.
9.3
Disconnecting the mains power supply
When the device is disconnected from the mains power supply, the internal battery
takes over the function of supplying power. The status display remains active on
main devices with corresponding gas mixer. Follow the instructions for storing the
device.
● Disconnect the power plug.
10
Alarms
10.1
Safety instructions
Alarm volume
If the alarm volume is too low, alarm signals may not be heard. The patient may be
put at risk.
► Set the alarm volume loud enough so that the alarm signals can be heard in the
environment where the device is located.
► The user must remain within earshot of the alarm signals.
Recognizing alarm signals
If alarm signals are not noticed, the patient may be put at risk.
► Dräger recommends that the user remains in the vicinity of the anesthesia
machine, i.e. within a distance of up to 4 meters (12 feet). This facilitates fast
recognition and response in the event of an alarm.
► If the causes of the alarm are only temporary, the alarms will likewise only be
indicated temporarily.
Impaired Infinity ID functions
Electromagnetic disturbances or faults in Infinity ID components can cause
permanent alarms.
► Contact service personnel to deactivate the Infinity ID alarms.
190
position.
|
Instructions for use
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
Advertisement
Table of Contents
