Dräger Atlan A100 Instructions For Use Manual page 210

Configuration
11.5.4 System setup > Therapy
11.5.4.1 Vertical tab "Vent. 1"
Headline/
Parameter
Default ventila- Buttons with available ventilation modes
tion mode
VT and RR start settings
Based on Patient category; Ideal body weight
Selected:
[Patient category]
VT 5 to 1500
[mL]
RR 3 to 100
[/min]
Selected:
[Ideal body weight]
VT
[mL]
RR
[/min]
The start settings for VT and RR influence the start values of the alarm limits for
MV high and MV low:
MV high = VT x RR x (1 + offset);
MV low = VT x RR x (1 – offset);
The "offset" value corresponds to the respective offset setting for automatic alarm
adjustment. The "offset" value can be set in System setup > Alarms > vertical
Autoset tab. If "Offset" is set to Off, the factory default value of 40 % is used for the
automatic calculation of the alarm limits.
210
Setting range
Man/Spon
5 to 1500
500 150
3 to 100
12 20
5 to 1500
100 kg (220 lb): 700
75 kg (165 lb): 520
15 kg (33 lb): 110
5 kg (11 lb): 35
3 to 100
100 kg (220 lb): 10
75 kg (165 lb): 12
15 kg (33 lb): 26
5 kg (11 lb): 32
minimal: 2.0 L/min
minimal: 0.3 L/min
Instructions for use
Description
Specifies the default ventilation mode at
the start of therapy.
Specifies the tidal volume and the
respiratory rate.
Specifies the tidal volume and the
respiratory rate based on the patient
category.
5 to 1500
50
3 to 100
30
Specifies the tidal volume and the
respiratory rate that are based on the
ideal body weight.
Set the tidal volume and the respiratory
rate for the supporting points 5; 15; 75;
100 kg (11; 33; 165; 220 lb).
For calculated values for ideal body
weights that lie between these 4 sup-
porting points, the start settings for tidal
volume and respiratory rate are interpo-
lated linearly. For ideal body weight val-
ues lying outside these supporting
points, calculation proceeds with the
values of the highest or lowest support-
ing point.
|
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n