Table of Contents
Advertisement
Configuration
Headline/
Parameter
Paw
+[mbar]; [hPa];
[cmH
O]
2
MV ± [%]
11.5.3.4
Vertical tab "Config. 1"
Headline/
Parameter
General alarm behavior
Open "Quick
setup" when
alarm occurs
"Second agent
detected" alarm
"xMAC low" alarm
"FiO
too high for
2
neonates" thresh-
old value [%]
"FiO
too high for
2
neonates" alarm
after [h:mm]
Priority of "Apnea
ventilation" alarm
Alarm behavior in "Pause" mode
Priority of "Pause
time expired"
alarm
Default value for
0:30 to 2:00
"Timer" [mm:ss]
208
Setting range
Off; 5 to 20
5
Off; 20 to 80
40
Setting range
On; Off
On; Off
On; Off
50; 25 to 90
Off; 0:10 to 9:50
0:15
Medium; Low
High; Medium
0:30 to 2:00
2:00
1:00
Instructions for use
Description
The following parameters are taken into
account when determining the Paw
value: PIP, Pplat, Pinsp, PEEP and
∆Psupp.
In the Man/Spon, Pause, and Monitor-
ing modes, the new alarm limit is at
least 25 hPa (cmH
In modes with low or no breathing sup-
port (Man/Spon, CPAP / PSV, Pause,
and Monitoring), a further
20 percentage points are added to the
configured value.
Description
Automatically opens the Quick setup
dialog in the event of an alarm.
Issues an alarm when an anesthetic
gas mixture is detected.
Activates the xMAC low alarm.
Sets the FiO
critical for neonates. If this value is
exceeded for a certain time, the FiO
too high for neonates alarm will be trig-
gered.
Sets the time after which the FiO
high for neonates alarm will be trig-
gered.
Specifies the alarm priority when the
set minimum respiratory rate is not
reached in PSV ventilation mode.
Specifies the alarm priority for the alarm
that is issued when the time set in the
Pause mode has expired.
0:30 to 2:00
Specifies the default duration for
0:30
Pause.
Is only applicable when switching to
Pause from a ventilation mode.
|
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
O).
2
value that is considered
2
too
2
2
Advertisement
Table of Contents
