Table of Contents
Advertisement
Tests
6. After the calibration is complete, remove the sealing cap and plug it back in the
holder.
Insert the O
reaches the end position.
7. After the calibration, the fully automatic main test is continued.
Note on the expiry of the life span of the O
The life span of the O
soon as there are 28 days or fewer of the life span left, the remaining life span will
be displayed in the system test. When the life span has expired, a corresponding
message and the following illustration will be displayed:
If the O
measurement will continue to be available. With an expired O
test result (operational with limitations) can be achieved at best.
Replace the sensor cell when the O
page 69.
138
sensor (4) back into the sensor port and turn it clockwise until it
2
sensor cell is 2 years and is monitored by the device. As
2
calibration is possible despite the expired O
2
Instructions for use
4
sensor cell
2
2
sensor can no longer be calibrated, see
2
|
Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n
sensor cell, the O
2
sensor cell, a yellow
2
Advertisement
Table of Contents
