• D D e e l l a a y y e e d d C C o o n n f f i i r r m m a a t t i i o o n n : This option shows the paper confirmation prompt for a specified time. At the end of

the specified time, the prompt closes, which confirms the paper that is loaded. While the prompt appears on the

control panel touch screen, you can confirm any change to the paper type, color, and size.

• A A u u t t o o C C o o n n f f i i r r m m a a t t i i o o n n : This option confirms the paper type, color, and size automatically without showing a

confirmation prompt on the control panel touch screen.

Note: Xerox does not recommend using the Auto Confirmation option unless you always load the tray

with paper of the exact same type, color, and size.

Note: To configure the Automatic Tray Confirmation Prompt, refer to R R e e q q u u i i r r e e d d P P a a p p e e r r P P o o l l i i c c i i e e s s in the System

Administrator Guide at www.xerox.com/office/ALB81XXdocs.

C O N F I G U R I N G T R AY S 3 A N D 4 O F T H E TA N D E M T R AY M O D U L E

Trays 3 and 4 in the Tandem Tray Module are high-capacity paper trays. Configure Trays 3 and 4 to support the

paper in use. For details on supported paper sizes, refer to

To configure Trays 3 and 4 in the Tandem Tray Module:

Note: Before you make any tray adjustments, compare the paper size to the current Tray 3 and 4

configurations. If the paper size matches the tray configuration, no tray adjustment is needed.

1. Remove any paper from the tray.

2. Pinch the guide lock on the front paper guide, then slide the paper guide to the required paper size.

3. To lock the paper guides into place, release the guide lock.

Note: The paper guides lock into place only at the designated standard paper sizes.

C O N F I G U R I N G T R AY 6