Dc136 Service Plan; Dc137 Page Pack - Xerox ColorQube 9303 Series Service Manual

Table of Contents

dC136 Service Plan

To allow the service plan to be changed from metered to sold. An authorization code is

required from the Xerox service centre.

Enter service mode,

Select the Maintenance tab.

Select dC136 Service Plan.

The service plan information is displayed.

Enter the authorization code to change the service plan.

NOTE: The authorization code generator can be down loaded from GSN library 10480.

NOTE: The service plan can be changed from and to any service plan.

Select Close to exit routine.

Select Call Closeout to exit service mode.

To apply the change switch the machine off and switch the machine on again,

General Procedures/Information

dC136, dC137

To enable or disable the page pack function. When enabled the page pack function, a cus-

tomer typically pays a fixed amount per month, or per page, for supplies and / or service plan.

Enter service mode,

Select the Maintenance tab.

Select dC137 Page Pack.

The Page Pack screen is displayed.

NOTE: The page pack function is only enabled in XE installations. Depending on the cus-

tomer's full service maintenance agreement, the page pack function needs to be enabled

when a USSG/XCL machine is installed in an XE region.

Select Disabled or Enabled.

Enter the PagePack passcode, a 4 digit authorization code. The authorization code can

be found in the customers machine installation pack.

The Save button will appear. Select Cancel or Save.

Select Call Closeout to exit service mode.

February 2013

ColorQube® 9303 Family

Table of Contents