Hardware Components; Electronics Control Module; Command Line Interface - Oracle StorageTek SL3000 Manual

Hardware Components

Inaccessible CAP area
1.
Robot parking area (inaccessible cartridge slots)
2.
Hardware Components

Electronics Control Module

■
Robotics
■
Rotational Cartridge Access Port (CAP)
■
Bulk Load Cartridge Access Ports (AEM)
■

Electronics Control Module

The electronics control module (ECM) is responsible for electronics control, robot and
drive control, and host connectivity. The ECM is located in the rear of the Base module
(see Figure
(drive controller).
Figure 1–5 Electronics Control Module
Figure Legend:
Serial port (reserved)
1.
Serial port (CSE port for CLI)
2.
Primary Ethernet port
3.
Dual TCP/IP Ethernet port
4.
Ethernet port (reserved)
5.

Command Line Interface

The command line interface (CLI) can be used by Oracle support to configure and
diagnose the library. Service representatives can access the CLI through the electronic
control module using either of the following:
Serial Port Connection on the HBCR card (RS-232) and a HyperTerminal
■
connection to enter the commands
Ethernet Port Connection (ports 1A, 2A, or 2B) on the HBCR card and a secure
■
shell (PuTTY) to enter the commands
1-6 StorageTek SL3000 Library Guide
1–2). The main controller cards are the HBCR (library controller) and HBT
The ECM ships with an optional MPU2 card (2Gb) or PUA2
Note:
card (8 Gb) for Fibre Channel interface connections. This card is not
shown in the figure but is installed below the HBCR card.