Isdn Network Interface Modules; Setting Up The V.35/Rs-449 Network Interface - Polycom ViewStation FX4000 User Manual

ISDN Network Interface Modules

Setting up the V.35/RS-449 Network Interface

© Polycom, Inc. 2002
This section explains how to install the following ISDN network
interfaces:
V.35/RS-449. See
on page 49.
PRI. See Setting up the PRI Network Interface on page
BRI. See Setting up the Quad BRI Network Interface on page
This section explains how to install and connect the V.35/RS-449
network interface module so that you can make calls over ISDN
with the ViewStation FX or VS4000 system.
The V.35/RS-449 network interface supports the V.35 or RS-449
protocol depending on the cable you use to connect your
equipment.
Connecting a V.35/RS-449 network interface module to your
ViewStation FX or VS4000
Make sure your ViewStation FX or VS4000 is turned off.
1.
2. Insert one end of the light blue keyed cable into the light blue
port on the back of the ViewStation FX or VS4000. The cable has
special RJ-45 connectors that are not interchangeable with
normal RJ-45 connectors.
3. Insert the other end of the light blue RJ-45 cable into the input
port labeled
Chapter 2 - Installing the ViewStation FX/VS4000
Setting up the V.35/RS-449 Network Interface
xon the network interface module.
52.
55.
49