Polycom ViewStation FX4000 User Manual page 313

Appendix A - Screen Reference
Auto Answer Point to Point—This option allows you to set the
Auto Answer mode for a point-to-point videoconference. It lets
you determine how the system will handle an inbound call. For
more detailed information about this option, refer to User Setup
Screen Reference, on page 309.
Auto Answer Multipoint—This option allows you to set the
Auto Answer mode for a multipoint videoconference. It lets you
determine how the system will handle an inbound call. For
more detailed information about the Auto Answer Multipoint
mode and the Dial-In Calling feature, refer to Dial-In Calling, on
page 237.
Allow Dialing—Enable this option to allow users to place calls
from the ViewStation FX or VS4000. If this option is disabled, the
ViewStation FX or VS4000 can only receive calls. You can still
place calls from the Web interface.
Allow User Setup—This option is used to enable or disable the
User Setup icon on the System Info screen. Administrators can
use this option to prevent users from changing the User Setup
functions.
Allow Address Book Changes—If this option is enabled, then
the user has access to the New, Edit, and Delete icons in the
Address Book screen.
Display IP and ISDN Information—Select this option if you
want your system's IP address and ISDN numbers displayed on
the main user interface for ease of use. If your system is IP only,
registered with a Gatekeeper, and has a Gateway number, this
number is displayed as your ISDN number on the main screen.
This option is enabled by default.
Keypad Audio Confirmation—This option enables an audio
response (English language) when a numeric key is depressed
on the remote control.
Maximum Time in Call—Enter the maximum number of
minutes allowed for call length. When that time has expired in
a call, you see a message asking you if you want to hang up or
stay in the call. If you do not answer within one minute, the call
automatically disconnects.
If you want your call to stay up indefinitely, delete the time
setting in the Maximum Time in Call field. Make sure to do the
© Polycom, Inc. 2002 315