Enabling Netmeeting On The Viewstation Fx Or Vs4000; Accessing Netmeeting - Polycom ViewStation FX4000 User Manual

Enabling NetMeeting on the ViewStation FX or VS4000

Accessing NetMeeting

© Polycom, Inc. 2002
If additional participants want to join a NetMeeting conference,
they can place a NetMeeting call to the IP address of either PC
in the call.
If you want to use the ViewStation FX or VS4000 data conferencing
capabilities, you must enable them on the ViewStation FX or
VS4000.
To enable NetMeeting on the Viewstation FX or VS4000:
Select System Info > Admin Setup > Data Conference. The
1.
Data Conference screen appears.
Enable either the NetMeeting or the T.120 device option. The
2.
ShowStation IP option appears only if a ShowStation IP is
connected to the ViewStation FX, the VS4000, or the LAN.
To access NetMeeting:
1. Place a point-to-point ISDN (H.320) call to the remote site. Make
sure the remote site has also placed a call to the local site.
2. Open Internet Explorer 4.0 or higher or Netscape 4.5 or higher
on your PC and enter the IP address of the ViewStation FX or
VS4000 in the Address field of your browser. The ViewStation
FX or VS4000 Web interface main page appears on your PC.
3. Click the Configure NetMeeting icon.
If an admin password is required, the Enter Network Password
window appears. The following information is needed:
a. Enter your name in the User Name field (use "admin" as
the user name).
b. Enter the admin password in the Password field. This
password is set in the Security screen (System Info >
Chapter 7 - Using the System with a PC
275