ISDN Network Interface Modules
Setting up the V.35/RS-449/RS-530 Network Interface
© Polycom, Inc. 2003
This section explains how to install the following ISDN network
interfaces:
V.35/RS-449/RS-530. See
Network Interface on page
BRI. See
Setting up the Quad BRI Network Interface on page
This section explains how to install and connect the
V.35/RS-449/RS-530 network interface module so that you can
make calls over ISDN with the system.
The V.35/RS-449/RS-530 network interface supports the V.35,
RS-449, or RS-530 protocol depending on the cable you use to
connect your equipment.
Connecting a V.35/RS-449/RS-530 network interface module to
your system:
1.
Make sure your system is turned off.
2.
Insert one end of the light blue keyed cable into the light blue
port on the back of the system. The cable has special RJ-45
connectors that are not interchangeable with normal RJ-45
connectors.
3.
Insert the other end of the light blue RJ-45 cable into the input
port labeled
Chapter 2 - Installing the ViewStation EX
Setting up the V.35/RS-449/RS-530
35.
xon the network interface module.
38.
35