Setting Up The Viewstation Fx - Polycom ViewStation FX4000 User Manual

Setting up the ViewStation FX

© Polycom, Inc. 2002
To connect your cables and equipment to the back of the
ViewStation FX:
1. Place the ViewStation FX on top of the television monitor with
the front lip overhanging the top of the television monitor.
2. Place the microphone pods on a flat surface between the
meeting participants and the television monitors. Do not place
the microphone pods near the television monitor speakers.
Connecting and disconnecting the microphones of the
ViewStation FX and VS4000 does not require a reboot of the
system.
3. Connect the required equipment and cables to the back of your
ViewStation FX as shown in the ViewStation FX QuickStart.
4. Connect any optional equipment to the back of your
ViewStation FX as shown in the ViewStation FX QuickStart.
Optional equipment can include a PC, VCR, telephone, audio
mixer, document camera, XGA projector or monitor, secondary
pan/tilt/zoom camera, or additional television monitors.
The colors on the cables match the colors on the back of the
ViewStation FX.
To prevent cable entanglement, wrap the enclosed cable tie
5.
around all of the cables.
Put the batteries in the remote control.
6.
You are now ready to set up your network interface. See
Network Interface Modules, on page 49
Chapter 2 - Installing the ViewStation FX/VS4000
Note
Note
for additional information.
ISDN
47