Setting Up Pri Options (T1 And E1) - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide

Setting up PRI Options (T1 and E1)

136
Line Termination (PRI E1 only)—Line termination is required
when there is power to the ViewStation FX or VS4000.
The PRI Setup screen lets you select the line signaling format, the
switch protocol, the CSU mode, and the line build out (depending
on the type of PRI that you have).
To access the PRI Setup screen:
Select System Info > Admin Setup > Video Network > IMUX >
PRI Network > PRI Setup. The following shows PRI Setup screens
for E1 and T1:
Figure 4-16. PRI Setup (E1) and PRI Setup (T1) Screens
You can access the Advanced PRI Setup screen from this screen. For
more information, refer to
T1).
The PRI setup information is generally obtained from the PRI
service provider. You can configure the following options on this
screen:
Note
Setting Advanced PRI Options (E1 and
www.polycom.com