Controlling The Near-Site Camera; Controlling The Far-Site Camera; Figure 5-11.Camera Control Button On Remote Control - Polycom ViewStation FX4000 User Manual

Controlling the Near-Site Camera

Controlling the Far-Site Camera

© Polycom, Inc. 2002
If there is no camera connected to the selected video source, you will
see either a blue screen or frozen video from the last video source.
Camera Control Mode—To control or adjust the camera on your
ViewStation FX or your VS4000, press the NEAR button on the
remote control. A camera icon appears in the upper right corner
pointing towards you.
Tilt, Pan—Use the arrow buttons on the remote control to tilt the
camera up and down and to pan from side to side.
Zoom—Use the ZOOM buttons to zoom in and out.
The following picture shows the buttons that are used on the remote
control to control the camera.
Figure 5-11. Camera Control Button on Remote Control
You can also adjust the camera on the far site in a call if that site has
its Far Control of Near Camera option enabled. Other sites can
control the camera on your ViewStation FX or your VS4000 if you
have this option enabled.
Chapter 5 - Using the ViewStation FX/VS4000
Note
201