With No Existing Point-To-Point Call; Auto Answer Multipoint Mode Configuration; Table 6-5.Dial-In Calling With An Existing Point-To-Point Call; Table 6-6.Dial-In Calling With No Existing Point-To-Point Call - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide

With no Existing Point-to-Point Call

Auto Answer Multipoint Mode Configuration

238
another site (1 site) and the resulting number of sites for that
multipoint call. For example, an incoming call (1 site) to an existing
point-to-point call (2 sites, one of which is the MCU) results in a
3-way multipoint call.
Table 6-5. Dial-In Calling with an Existing Point-to-Point Call
Number of Incoming Calls to
MCU
1
2
2 simultaneous
The following table assumes that there is no existing point-to-point
call. The table describes the number of calls that can be separately or
simultaneously placed to the ViewStation FX or VS4000 embedded
MCU (1 site) and the resulting number of sites for that multipoint
call. For example, three incoming calls (3 sites) to the MCU (1 site)
result in a 4-way multipoint call.
Table 6-6. Dial-In Calling with no Existing Point-to-Point Call
Number of Incoming Calls to
MCU
1
2
3
2 simultaneous
3 simultaneous
It is necessary to set the Auto Answer Multipoint mode to determine
how the system will handle an incoming call.
Result
3-way multipoint call
4-way multipoint call
4-way multipoint call
Result
1 point-to-point call (2-way call)
3-way multipoint call
4-way multipoint call
3-way multipoint call
4-way multipoint call
www.polycom.com