Figure 2-6.Pri Network Interface Module (Network Side) - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide
54
2. Power on the television monitor.
3. Power on the ViewStation FX or VS4000. Once you power up the
system, there is a 20-second delay before you see the Polycom
logo.
4. Once your interface is properly connected, you are ready to
configure your ViewStation FX or VS4000. Proceed to chapter
Initial System Setup, on page
Figure 2-6 shows the NETWORK side of the PRI network interface
module that connects to the ISDN PRI network.
Figure 2-6. PRI Network Interface Module (NETWORK side)
Special Information
Crossover Cable. An RJ-45 crossover cable might be required when
connecting the PRI network interface module to a PBX or another
third-party network access device.
External PRI Power Source. Please carefully read the Notes on
page 53.
External CSU. If you are using an external CSU (North America T1
only), connect an RJ-45 cable from the CPE equipment side of the
CSU to the PRI network interface module.
PRI Cable Adapter Kit. You can also purchase an additional cable
adapter kit (available through your reseller) to extend the distance
between your ViewStation FX or VS4000 and the PRI network
interface module.
LED Information. Refer to the PRI Technical Information section of
the Polycom Office Integrators' Reference Manual.
71.
NETWORK
Connector
LEDs
www.polycom.com