Send A Message - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide

Send a Message

282
You can also take snapshots from the Remote Control screen using
one of the three snapshot buttons.
To access and use the virtual remote control:
From the System Diagnostics Web screen, click the Remote Control
icon to use the Web interface remote control.
To use the virtual remote control, you must use Internet Explorer 4.0
or higher as your Web browser.
To use the snapshot feature:
Click the appropriate button to select your source (Snapshot from
Camera 1, Snapshot from Camera 2, or Snapshot from VCR).
The Start Streaming Snapshots feature lets you stream snapshots of
the room where the ViewStation FX or VS4000 system is located at
regular intervals. Each snapshot is displayed for a few seconds. You
can set the display time in the Snap Interval field.
This utility lets you send a message to the system that you are
managing. Only the near site can see your message.
To send a message using the web interface:
From the System Diagnostics Web screen, click the Send
1.
Message icon to send a message to a ViewStation FX or VS4000.
The text message can be up to 100 characters in length.
2. When the Send a Message Web page appears, type in your
message and click the Send Message button. Your message
appears on screen for 15 seconds on the ViewStation FX or
VS4000 that you are managing.
Note
www.polycom.com