GRAPHTEC FCX2000 Service Manual page 204

Error cord No.
E01017
FCX2000-UM-251-9370
LCD Display
The Y bar hits something
and then stops when it is
moving.
The X home sensor is
defective.
The model setting did
not set to the correct
model after the main
board was replaced.
The home position was
not set to the correct
position after the main
board was replaced.
The X motor is defective. Replace the X motor if the
The main board is
defective.
10-16
10 TROUBLESHOOTING
Cause
Remove the object disturbing
the operation, and then turn
on the power after turning off
the power.
Replace the X home sensor
when the Y bar moves +X
direction slowly and the X
position error is displayed.
Set the correct model
when the X position error
is displayed after the Y bar
moved to the right side end.
Confirm the model name on
the LCD after the power was
turned on.
Set the correct home position
when the X position error
is displayed after the Y bar
moved to the right side end.
Y-bar moves quickly when it is
cutting the X direction.
Replace the main board
when the X position error is
displayed without moving the
Y bar.
Solution