9.18 About Start Up Mode
It starts up in each start mode when starting while pressing the key to the table below when the power supply
is turned on.
Key
Upper arrow
Right arrow + left arrow
Slow + ENTER
Lower arrow + ENTER
FCX2000-UM-251-9370
Mode
Setup Clear
System firmware update
Maintenance Mode
Adjustment copy mode
9
Remark
The cutting conditions are returned to the factory set-
ting. If your customer is changing conditions, you
should print out the condition list before performing this
mode.
Electrical adjustment mode.
Copy the adjustment values from the Sub-NVRAM to
the Main board.
9-41
ELECTRICAL ADJUSTMENTS
Need help?
Do you have a question about the FCX2000 and is the answer not in the manual?