GRAPHTEC FCX2000 Service Manual page 33

(16) Attach the Warning Light Cover Angle to the rear left corner of frame by using the two M4L8 binding
head screws.
(17) Attach the Warning Light Side Cover to the rear left corner of frame by using the three M4L8
binding head screws.
(18) Attach the left rear cover of warning light by using the four M4L8 binding head screws.
Left rear cover of warning light
(19) Confirming the warning light operation
Confirm the all Light on the warning light is lit (Green, Red, and Yellow) after the warning light was
installed.
• Turn on the power for the FCX2000, and then confirm all Light on the warning light is lit.
• The warning light test function is in the maintenance mode from the firmware version 2.10 (Page 5/5).
Confirm the warning light operation with one of above function.
FCX2000-UM-251-9370
Warning Light Cover Angle
M4L8 binding head screw
Warning Light Side Cover
M4L8 binding head screw
2-18
2
M4L8 binding head screw
Setup procedure