GRAPHTEC FCX2000 Service Manual page 182

(10) Press the F2 key (SCAN). The following menu is displayed.
(11) Use the Position keys to move the pen position to the printed cross mark area shown below.
Printed target mark
Note: Position the pen-tip to the area above. Do not position the RMS sensor to the area above.
(12) Press the ENTER key after positioned the pen-tip.
(13) The plotter scans the printed cross mark and then the plotter then plots a new cross mark based on the
reading of the printed cross mark.
The following menu is displayed.
(14) Measure the offset between the printed cross mark and plotted cross mark.
Cross mark
plotted by the
plotter
FCX2000-UM-251-9370
10 mm
X
Y
Printed target mark
9 ELECTRICAL ADJUSTMENTS
Media feed
direction
Move the pen position into this area.
+Y
-X
-Y
9-36
+X