GRAPHTEC FCX2000 Service Manual page 36

(7) Cut the rubber cap (C-30-SG-30A-EP-UL) as shown in the picture below by using knife.
(8) Install the rubber cap (C-30-SG-30A-EP-UL) to the FRAME_ANGLE>_P.
(9) Disconnect all cable from the main board to replace the control box.
(10) Release the X flexible cable and the X home sensor cable from the cable tie.
And then disconnect the X flexible cable and the X home sensor cable from the main board.
X home sensor cable
Disconnect the X flexible cable from this connector.
FCX2000-UM-251-9370
Rubber Cap
Rubber Cap
X flexible cable
Release this cable tie.
Cut the rubber cap on a cross.
FRAME_ANGLE_P
Disconnect the X home sensor cable
from this connector (J9).
2-21
2 Setup procedure