Running Cutting Tests; Cutting Test - GRAPHTEC FCX2000 Service Manual

4.9

Running Cutting Tests

Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results.
Check how far the blade cuts into the media and how the corners are being cut.
If the cutting results are not satisfactory, adjust the various settings and repeat the test cutting until the
optimal settings are achieved.
4.9.1

Cutting Test

To make 1 cut with set value
(1) Load the media for test cutting in the plotter.
(2) Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/4) is displayed.
(3) Press the POSITION ( ) key (CUT TEST).
(4) Press the POSITION (▲▼▲▼) keys to move the tool carriage to the location you wish to perform the
test cutting.
(5) Press the [ENTER] key.
1 cut test pattern is cut.
(6) Press the [ESC] key after completion.
CUT TEST screen is displayed.
(7) Press the [COND/TEST] key.
It will return to default screen
FCX2000-UM-251-9730 4-23
4. OPERATIONS