GRAPHTEC FCX2000 Service Manual page 102

(6) Confirm the X flexible cable is fitting to the vertical plate of Y bar as shown in the picture below.
Good
This part must fit to the vertical plate of Y bar
when the X flexible cable is installing.
(7) Move the Y bar to the end of right side.
(8) Make the 10 mm slack on the right side of Y flexible bracket.
FCX2000-UM-251-9370
8 DISASSEMBLY AND ASSEMBLY
No good
The X flexible cable will be damaged by the rear
top cover when the X flexible cable did not fit to the
vertical plate of Y bar as like as this picture.
8-27