The Pen Block Was Replaced; The X Home Sensor Was Replaced; The Y Home Sensor Was Replaced; The Registration Mark Sensor Was Replaced - GRAPHTEC FCX2000 Service Manual

9.2.3

The pen block was replaced

When the pen block was exchanged, perform the following adjustments.
9.2.4

The X home sensor was replaced

When the X home was exchanged, perform the following adjustments.
9.2.5

The Y home sensor was replaced

When the Y home was exchanged, perform the following adjustments.
9.2.6

The registration mark sensor was replaced

When the registration mark sensor was exchanged, perform the following adjustments.
FCX2000-UM-251-9370
9.10 Adjusting the Home Position
9.11 Adjusting the Pen Force
9.13 Adjusting the Tool Interval
9.14 Adjusting the Registration Mark Sensor Sensitivity
9.15 Adjusting the Offset of Registration Mark Sensor
End of Adjustment
9.10 Adjusting the Home Position
End of Adjustment
9.10 Adjusting the Home Position
End of Adjustment
9.14 Adjusting the Registration Mark Sensor Sensitivity
9.15 Adjusting the Offset of Registration Mark Sensor
End of Adjustment
9 ELECTRICAL ADJUSTMENTS
9-4