New Holland WorkMaster 50 Service Manual page 535

Front wheels - Toe in adjust – 2WD
Front wheel toe-in test
When the tractor moves along a straight line, wheels
should be parallel to the tractor centre line or slightly
toe-in until a max. of 0.50 mm (0.02 in), measured be-
tween the rim edges.
Check the correct toe-in as follows:
1. Inflate front tires to a pressure of 1.7 bar (25.0 psi).
2. Place the steering wheel at mid-travel, with one spoke
along the tractor centre line.
3. Check if wheels are parallel to the tractor centre line.
4. Measure the distance (B) between the wheel inner rims
at hub height at the front of the wheels.
5. Measure the distance between the wheel inner rims at
hub height at the rear of the wheels. The measurement
taken should be the same as (B) or greater by up to
5.00 mm (0.20 in) max.
6. If it is necessary to adjust the front wheel toe-in, pro-
ceed as follows:
• Loosen the clamp (1) on both end of the track control
rod.
• Turn the track control rod (2) in or out to shorten or
lengthen the track control rod until desired toe-in is
achieved.
• Tighten the clamp (1).
Wheels - Front wheels
47866583_ 02/12/2015
44.1 [44.511] / 4
1
GNIL14TR04458AB
2
GNIL14TR04459AB