36. Remove the nut using wrench, tool no 380000268
(1), while holding the bevel drive pinion shaft against
rotation with wrench, tool no 380000257.
37. Remove the splined shaft detent ball (1).
38. Remove the bevel drive pinion shaft (1) from the
rear of the casing and remove the spacer, the adjust-
ment shims and the bearing.
NOTE: Observe the quantity and the size of the shims re-
moved from the pinion shaft.
39. Using a screwdriver, remove the dust seal, seal ring
(1) and rear bearing.
Front axle system - Powered front axle
47866583_ 02/12/2015
25.1 [25.100] / 24
21
GNIL14TR04388AB
22
GNIL14TR04389AB
23
GNIL14TR04390AB
24
GNIL14TR04391AB