New Holland WorkMaster 50 Service Manual page 416

Main lift system - Assemble
Draft sensing unit
Assemble and reinstall sensing unit on hydraulic hous-
ing observing the following:
1. Assembly and reinstallation follows the removal proce-
dure is reverse from step 7 to step 1.
2. Tighten all fasteners to correct torque. See Main lift
system - Torque (35.100).
3. The top face of spring roller:
• Should be 1.000 mm (0.039 in) above the top face
of flange.
• In case, if it is less add shims and if more remove
shims.
4. Refer to page for correct settings.
Rear lift internal controls
5. Re-assembling follows disassembly procedure in re-
verse.
Lift arm shaft
6. Reinstall the shaft and lift arm in the lift housing observ-
ing the following:
• Reinstallation follows the removal procedure in re-
verse. Refer to Main lift system - Disassemble
(35.100) from step 6 to step 1.
• See Main lift system - Install (35.100) for reinstal-
lation of lift assembly on tractor.
• Check the seals (1) and replace if required.
• Use special tool number 9970873 to fix the seal.
• Tighten all fasteners to correct torque as detailed in
Main lift system - Torque (35.100).
Hydraulic systems - Main lift system
47866583_ 02/12/2015
35.2 [35.100] / 21
1
GNIL14TR04622AA
2
GNIL14TR04647AB