6. Remove the tie rod retaining nuts (1).
7. Using a removal tool, remove the tie rod ends from
their bores in the stub axle housing.
8. Remove the snap ring from the bottom of the cylinder
rod pivot pin (1)
9. Remove the pin retaining bolt (2) from the pin. Re-
move the pins and detach the cylinder.
10. Unscrew the retaining bolts off the left-hand final
drive casing cover (1).
11.
Screw in the two M10 x 100 dowels tool no
380002813 (2).
12. Using a slide hammer puller screwed into the oil
drain plug.
13. Detach the cover (1) from the casing.
Front axle system - Powered front axle
47866583_ 02/12/2015
25.1 [25.100] / 20
5
GNIL14TR04371AB
6
GNIL14TR04372AA
7
GNIL14TR04373AB
8
GNIL14TR04374AB