New Holland WorkMaster 50 Service Manual page 186

Driven shaft - Install Transmission drive and driven shafts
NOTE: Before assembly carefully check gears needle bearing snap rings etc. and replace if found faulty.
1. Fit the oil connector (1) between driven shaft and pin-
ion keeping larger diameter towards driven shaft before
fitting driven shaft on pinion.
2. Install the driven shaft (1) into the housing.
NOTE: 3rd and 4th gears are a integral part of the driven
shaft.
3. Install the 4th gear drive gear (1) onto the range shaft.
4. Secure the 4th gear drive gear (1) with the snap ring
(2).
Transmission - Gearbox internal components
47866583_ 02/12/2015
21.4 [21.145] / 23
1
GNIL14TR04184AB
2
GNIL14TR04185AB
3
GNIL14TR04186AB
4
GNIL14TR04187AB