New Holland WorkMaster 50 Service Manual page 766

From
X-9008 pin 2
X-9008 pin 2
X-9008 pin 2
X-9001 pin A28
A. If there is no continuity, leave connector X-9008 disconnected and continue to Step 5.
B. If there is continuity, there is a a short circuit in the camshaft position sensor B-9017 wiring. Locate and repair
the broken conductor.
5. Replace the camshaft position sensor B-9017.
Use the Electronic Service Tool (EST) to verify the status of this fault, DTC 143-Min - Camshaft sensor failure.
A. If the fault has been resolved, return the machine to service.
B. If the fault has not been resolved, check the ECU A-9000 for the appropriate software and re-flash, if necessary.
6. Visually inspect the relevant harnesses and connectors for damage, bent or dislocated pins, corroded terminals,
or broken wires. Verify that the connectors are fully installed. Flex the harnesses involved to reveal intermittent
breaks or shorts in the wiring concerned. Operate the machine while you monitor the display.
A. If you find damage or the display indicates other than normal display readings, then repair the damage discov-
ered during the inspection or locate and repair the other than normal display condition and verify that the error
has been resolved.
B. If you do not find damage and the display indicates only normal readings, then erase the fault code and continue
operation.
Wiring harnesses - Electrical schematic sheet 03 – Engine sensors and fuel injection (engine schematics)
(55.100.DP-C.20.E.03)
Electrical systems - FAULT CODES
To
Chassis ground
X-9008 pin 1
X-9008 pin 3
All pins in connector X-9001
47866583_ 02/12/2015
55.12 [55.DTC] / 45
Value
There should be no continuity.
There should be no continuity.
There should be no continuity.
There should be no continuity.