New Holland WorkMaster 50 Service Manual page 88

Power Take-Off (PTO) clutch lever removal
To remove the Power Take-Off (PTO) clutch lever (1)
proceed as follows:-
1. Remove pin (1) by releasing lock plate and dis-
connect linkage between Power Take-Off (PTO) clutch
lever and Power Take-Off (PTO) clutch cross shaft.
2. Remove the split pin lock (1) take out the pin and
remove hand lever from the mounting bracket.
3. Remove bolt (2) from the housing to take out the
levers with the bracket.
Cross shafts removal
To remove cross shafts clutch housing has to be split
between engine flywheel housing and transmission
housing.
1. Remove clips (1) from both the forks and release
bearings and take out release bearings.
Clutch - Clutch mechanical release control
47866583_ 02/12/2015
18.1 [18.100] / 5
8
GNIL14TR00781AA
9
GNIL14TR04671AB
10
GNIL14TR04673AB