7. Install shims, (1), as near as possible to the calculated
value. Use a dial gauge and following the procedure
described above, check that the end float of the left
and right-hand side gears is approximately 0.25 mm
(0.010 in).
Differential side gear shim sizes
Available shim sizes mm (inches)
1.0 mm (0.039 in)
1.1 mm (0.043 in)
1.2 mm (0.047 in)
1.3 mm (0.051 in)
1.4 mm (0.055 in)
1.5 mm (0.059 in)
Front axle system - Front bevel gear set and differential
1.6 mm (0.063 in)
1.7 mm (0.067 in)
1.8 mm (0.071 in)
1.9 mm (0.075 in)
2.0 mm (0.039 in)
47866583_ 02/12/2015
25.2 [25.102] / 4
3
20097714